Last Updated on May 20, 2019
This instructional video demonstrates a MINIPURE® Ultraviolet Water Purifier Lamp and Quartz Sleeve removal and replacement.MINIPURE® UV Water Purifier Lamp Removal
SAFETY EQUIPMENT REQUIRED TO PERFORM TASK
Step 1
WARNING: Disconnect power to the MINIPURE® Ultraviolet Water Purifier
Step 2
Remove EASY-OFF™ End Cap by pulling cap off static gland nut. Slide end cap along the wire away from the socket.
Step 3
Carefully withdraw lamp approximately 2 inches from chamber to reveal lamp socket.
Step 4
While holding lamp end, carefully remove lamp socket on now exposed end.
Step 5
Carefully remove lamp from chamber. Be sure to withdraw lamp straight
out without angling until completely clear of quartz sleeve.
CAUTION: Lamp and quartz sleeve are easily damaged. Exercise care when handling
MINIPURE® UV Purifier Quartz Sleeve Removal
Step 1
Remove the other EASY-OFF™ End Cap by pulling cap off static gland nut.
Step 2
Unscrew static gland nut from end of the chamber. Avoid striking quartz sleeve with static gland nut.
Step 3
Remove Teflon® washer from end of quartz sleeve. Teflon® washer will sometimes remain within the static gland nut.
Step 4
Remove O-Ring from end of quartz sleeve.
Step 5
Unscrew static gland nut from end of the chamber. Avoid striking quartz sleeve with static gland nut.
Step 6
Remove Teflon® washer from end of quartz sleeve. Teflon® washer will sometimes remain within the static gland nut.
Step 7
Remove O-Ring from end of quartz sleeve.
Step 8
Carefully remove quartz sleeve from chamber. NOTE: It is advisable to support the quartz sleeve on the opposite end
with your finger so that it does not drop to the bottom of the chamber as it slides into the chamber.
MINIPURE® UV Purifier Quartz Sleeve Installation
Step 1
Carefully slide quartz sleeve through chamber. Be sure to use your finger on the far end to support the sleeve and carefully guide it into the static gland nipple. Make sure the quartz sleeve protrudes an equal distance past each threaded nipple.
Step 2
Affix O-ring to quartz sleeve.
Step 3
Affix Teflon® washer to quartz sleeve.
Step 4
Screw on gland nut, DO NOT USE HAND TOOLS. Tightening with hand tools is likely to cause quartz sleeve to break.
Step 5
Attach EASY-OFF™ End Cap to static gland nut.
Step 6
Affix O-ring to quartz sleeve.
Step 7
Affix Teflon® washer to quartz sleeve.
Step 8
Screw on gland nut, DO NOT USE HAND TOOLS. Tightening with hand tools is likely to cause quartz sleeve to break.
MINIPURE® UV Purifier Lamp Installation
Step 1
Carefully slide lamp through chamber straight without angling.
Step 2
Connect socket to end of lamp.
Step 3
Attach EASY-OFF™ End Cap to static gland nut.
For more information on the MINIPURE® UV Water Purifier, visit our MINIPURE® overview page or download the MIN-1 to MIN-3 owner’s manual or MIN-6 and MIN-9 owner’s manual
Shop MINIPURE® Ultraviolet Water Purifiers and replacement parts at BuyUltraviolet.com.
Need help? Call Our UV Specialists at 1-631-273-0500, Monday – Friday 7am to 6pm EST
CM-000047 x
